Amulet Hotkey DXZ4-A, Руководство пользователя

Страница: 34 / 44

DXZ4 security edition zero client
Page 34
5. Select the BSM network enable check box. See Figure 25 .
Figure 25:
BSM.network.enable.option.selected
6. Verify that the target zero client is powered On.
7. Click
Apply
. The BSM now acquires an IP address
from the DHCP server.
8.
Now make a note of the BSM IP address from the network
page. You may need to refresh the browser.
7.1.3 Transfer the firmware package to the target BSM
Use a TFTP server to transfer the .bsm file containing the
firmware package. As an example, these instructions use the
Tftpd32 utility, available from http://tftpd32.jounin.net/
1. Verify that the target zero client is on or in standby.
2. Launch the
Tftpd32 utility.
3. When Tftpd32 starts, go to the Tftp Client tab.
Figure 26:
TFTP.utility.client.settings.window.
4. Enter the following settings:
Setting Value
Host: Enter the BSM IP address.
Port
Set to port 69. Note that port 69 on the BSM is
used to initiate the transfer. The actual port used
during the transfer is randomly assigned.
Local File:
Browse to the .bsm file containing the firmware
update. You can retrieve this file from anywhere
accessible on your network.
Remote File: Leave this setting blank
Block Size: Set to 512 bytes.
Table 8: TFTP.utility.client.settings
5. Click Put to start the package transfer.
6. After the BSM receives and validates the package, the BSM
restarts automatically.
7.1.4 Confirm that the firmware has updated
Note: If the zero client was On and in a session while the
firmware was updated, it automatically restarts after the
session has ended. The zero client does not apply the new
firmware until it restarts.
1. When the zero client restarts, log on to the Administrative
Web Interface (AWI).
2. From the home page, select the Configuration > Network
page. See Figure 25 .
3. Check the firmware version next to BSM Firmware Version is
the new version.