AMT “Reincarnator” RD-2
23/10/17
Rear panel:
1.LINE INPUT(1) – is unused
2.LINE OUTPUT MIC LEVEL(2) -> Sound Card Balanced Mic Input
3.GND/LIFT(3) – is in a lower hum position
4. 9-18VDC(4,5) <- DC power supply (center minus)
C. Power Amp is a Source. Active mode only.
Front panel:
1.Power Amp -> INPUT (2) TS-TS cable
2.THRU – Guitar Cab or LoadBox TS-TS cable
3.Button BUF OFF/ON(4) is in ON position (pressed)
4.Button AMP/GTR(6) is in AMP position (unpressed)
5.IN ATT Knob is in proper position
6.Button DI/REamp(1) is in DI position (unpressed)
7. REAMP OUT(9), LINK(10) are not used
8. PHASE 0/180(11) and REAMP BOOST +12dB +6dB 0dB – are no matter
Rear panel:
1.LINE INPUT(1) – Note: in active mode you can use this input as a line level output (balanced or
unbalanced)
2.LINE OUTPUT MIC LEVEL(2) -> Sound Card Balanced Mic Input
3.GND/LIFT(3) – is in a lower hum position
4. 9-18VDC(4,5) <- DC power supply (center minus)
2.4
R
EAMPING
,
R
E
A
MP
-
MODE
.
P
OSSIBLE SETS
:
A. Passive mode.
Front panel:
1. INPUT(2) is unused
2. THRU(3) is unused
3. Button BUF OFF/ON(4) is no matter
4. Button AMP/GTR(6) is no matter
5. IN ATT Knob(8) is no matter
6. Button DI/REamp(1) is in REamp position (pressed)
7. REAMP OUT (9) -> AMP’s input
8. LINK(10) is not used
9. Button PHASE 0/180(11) is in a proper position
10. REAMP BOOST +12dB +6dB 0dB(13) is in 0dB position
Rear panel:
1.LINE INPUT(1) <- Sound card output (balanced or unbalanced, XLR,TRS or TS)
2.LINE OUTPUT MIC LEVEL(2) is not used
3.GND/LIFT(3) – is in a lower hum position
4. 9-18VDC(4,5) – is not used
B. Active mode.
Front panel:
1. INPUT(2) is unused
2. THRU(3) is unused
3. Button BUF OFF/ON(4) is no matter
4. Button AMP/GTR(6) is no matter
5. IN ATT Knob(8) is no matter
6. Button DI/REamp(1) is in REamp position (pressed)
7. REAMP OUT (9) -> AMP’s input
