Acoustic Instrument Transmitter
6
1
.
Each AMT microphone has a disconnect. (D.C.T.) Connect the cable from the Q7
Transmitter to the 3pin (Ta3) input connector on the microphone.
2
.
Adjustable Gooseneck
Adjustable at angle to allow sound to escape from instrument and develop naturally.
3
.
Mounting Screw
To REINFORCE the transmitter’s stability on the bell of saxophone / horn, rubber
protection avoids damage of the instrument.
4
.
BATT/PO
Power and battery LED, the blue LED remains lit as long as the transmitter has power;
if the blue LED is flashing, the battery need to be replaced immediately.
5
.
Mute Button
6
.
Light touch power switch
Tap to turn on, long press (2 seconds) to turn off.
7
.
Antenna
1/4 wave-length wire type antenna, MUST be fully connected and extended during
normal operations. Reception will be poor without antennas connected.
8
.
IR infrared port
Receiver infrared beam to synchronize frequencies, hold the transmitter with its IR
port facing directly towards the receiver’s IR port with a distance between 5-20cm.
9
.
Battery compartment
Insert a standard AA alkaline battery here, make sure to put the battery in the right
polar directions.
10
.
Battery cover
Pull back gently on this cover at the ribbing and pry upwards to remove
