www.amtelectronics.com
www.amtelectronics.com
5
5
What’s new in hardware version 1.11
Congratulations on becoming an owner of FS-2MIDI with new improved hardware version 1.11! If compared with the previous version the pedal received new
functional abilities in term of external devices control by means of MIDI protocol.
When the pedal is on you’ll see the following:
New mode named
allows to flip up/down Program Change commands within 0…127 range (in command mode
) or parameters of any chosen
Control Change command (in command type mode
). The switching in FSW 1&2 OUT connector is the same as before entering
mode and can’t be
changed because both footswitches are used for flipping through corresponding commands. It’s also good to remember that the device does not receive MIDI commands in this
mode and only reroutes received signals to MIDI OUT.
Swtching and operation in
mode
To engage
mode do the following:
Another button
L
pressing will result in Program Change command transfer via MIDI interface (in command type mode
) or parameter of chosen Control
Change command (in command type mode
) decreased by 1 (after minimum value of 0 goes 127).
Pressing
R
will result in Program Change command via MIDI interface (in command type mode
) or parameter of chosen Control Change command (in
command type mode
) increased by 1 (after maximum value of 127 goes 0).
Pressing
R
or
L
for over 1.5 s engages auto repeat used for quick flipping through commands.
Selection of Control Change command to be sent in
mode (at chosen command type
)
In order to enter the general MIDI channel adjustment menu, command type and operation mode without changing adjustable Control Change command press both
L
+
R
simultaneously
.
Press
L + R
to
store setting
Blinking indicator confirms
setting storage
Main Mode
Press
R
or
L
until
OP.1c
indication appears
Main Mode
Press
L + R
>1.5 sec
Press
L + R without
changing
previous setting
Press
L + R without
changing
previous setting
Choosing MIDI command type
сс – Control Change,
Pc – Program Change
Choosing mode OP.1c,
OP.2c, OP.3c or OP.4c
MIDI command
type - CC
(Control Change)
MIDI command
type - PC
(Program Change)
MIDI channels 1-16
setting
Press
L + R
to
store setting
Main Mode
Press
L + R
>1.5 sec
Press
R
to increase number
(after 127 follows 0)
Press
L
to decrease
number (after 0 follows
127)
Indication of adjustable
Control Change command
Blinking indicator confirms
setting storage
Main Mode
