American Security Products Co.
ESL15 Operating Instructions
Released Aug. 9, 2018
Revision A
Page 1 of 10
ESL15 Electronic Lock Operating Instructions
The ESL15 uses a fixed length 6-digit combination. Your AMSEC ESL15 Electronic Safe Lock has a default factory
combination of: 1-2-3-4-5-6.
Opening Your ESL15 Lock for the First Time
1.
Press the “C” key.
2.
Key in the factory preset combination.
3.
Press the “#” key.
If the combination was entered correctly, the lock will cycle open for three seconds. During this 3-second period,
turn the handle of the safe to the unlocked position and pull the door open.
Changing the ESL15 Master User Combination
You may change your combination any time you’d like and as many times as you’d like. To insure security once
your safe is installed, you must change the factory preset combination to a new 6-digit combination.
CAUTION:
Combination changes should always be done with the door OPEN to prevent accidental lockout.
1.
Press the “C” key.
2.
Press the “#” key. You should hear a short warbling tone and see the red LED flash.
3.
Key in your old 6-digit combination.
4.
Press the “#” key. You should hear a short good combination tone.
5.
Key in your new 6-digit combination.
6.
Press the “#” key. You should hear a short good combination tone.
7.
Re-key in the new 6-digit combination again.
8.
Press the “#” key. If the combination input matches the first pass, you should hear a long good combination
tone indicating your new combination has been recorded.
9.
Test your new combination several times prior to closing and locking the safe.
Note:
See the ESL15 Beep and LED Patterns table on Page 10.
See
Changing User Combinations
section for instructions on changing combinations for Users other
than the Master User.
Low Battery Warning
The ESL15 lock provides a warning when the battery is getting low.
When the battery power drops to a near critical level, after a normal lock opening cycle is completed, a
low battery warning warble tone will sound for 3 seconds and the keypad LED(s) will flash. The lock will
not open soon.
Change your Battery!
A Few Things to Remember
With each keystroke, the red LED on the keypad will flash and the beeper will chirp.
If 4 incorrect combinations are entered, the lock will go into Penalty Lockout for 15 minutes to prevent
trial-and-error attempts at opening the lock. The red LED will flash once every 5 seconds during this period.
