AMSAN AM-TPL10F, Руководство пользователя

Страница: 14 / 30

Two Post Car Lift AM-TPL10F
14
•
After removing the shipping racks holding the two columns together, remove
top and bottom of the posts out of the skid and discard the steel racks.
•
Remove all the parts and compare them with the parts list (at the end of this
manual).
•
Contact us if there are any parts missing.
•
Please make sure you read the space, foundation and installation
requirements and anchoring guidelines thoroughly in previous pages. The area
where the lift will be located should be free of overhead obstructions such as
heaters, building supports, electrical wires and so on. Also make there is
enough clearance around the lift for driving vehicles getting on or off the lift.
•
By using a chalk, draw an outline of the base plate on the installation ground
and establish the position for the two posts
•
Double check all dimensions and make sure that the layout is square.
Step 2.
•
Ascertain the side where the power unit post will be located. Please remember
this is the post where your main electrical power supply will be connected.
It is
highly recommended to locate the power side with the passenger side of the
vehicle when loaded on the lift to save steps during operation.
•
Double check all dimensions and make sure that the layout is square.
and aligned with the chalk line.
•
Stand up the power unit post (this post has the power unit bracket welded on)
and position it inside the chalked lines. Position the post toward the other
post. Please see the picture below.