TMD2635
● TMD2635 EVM
Software Installation
Quick Start Guide
• PUBLIC
QG000142
• v2-00 • 2022-May-19
9
│ 4
2
Software Installation
1.
Plug the
ams
flash drive into an unused USB port
2.
Double-click the
Setup.exe
file on the flash drive, or click Start > Run and type E:setup.exe and
press Enter.
IMPORTANT:
Use the appropriate drive letter in the above command to install the
software. Flash Drive will commonly be assigned the next available drive letter for example C:
hard drive, D: CD-ROM, E: flash drive
3.
The Setup Wizard will open and guide you through the installation of the TMD2635 host
software, (Figure 2 through Figure 8)
4.
The EVM Controller board requires the installation of FTDI CDM drivers. If these drivers are not
installed on your machine, this setup will automatically launch the installer for the FTDI drivers.
5.
At the end of the installation, click Finish to exit the setup.
Figure 2:
Welcome Screen
Figure 3:
Liability Disclaimer