JetCis_130
Hardware Description
Eval Kit Manual
• PUBLIC
UG000473
• v2-01 • 2020-Aug-10
28
│ 6
Mounting holes are present on the sensor board to connect a tripod mount to the tripod, see Figure 3.
There is the possibility to extend the legs of the tripod. Besides those holes, there are also mounting
holes for the lens holder to add a lens. Out of the box, the lens holder is already screwed onto the
sensor board including the S-mount lens. The lens can be screwed out of the lens holder in case the
user wants to do specific measurements without a lens. To focus the lens, simply rotate until the
image is sharp.
Attaching the tripod:
Mount the sensor board onto the black tripod adapter mount with the provided screws.
Screw the tripod in the black adapter mount.
Extend the tripod legs to the desired length.
Figure 3:
Mounting Holes: Tripod (left); Lens (right)
1.
3.3
Interposer Board (TX2 only)
The interposer board makes the connection possible between the sensor board and the NVIDIA
Jetson TX2. Both boards are linked to each other by using a flex cable. This is illustrated in Figure 4.
The electrical components mounted on the interposer board are not being used, but were provided as
a backup solution or as an alternative for the PMIC on the sensor board. Also on this board, test pads
are provided. Refer to chapter 6.2 for a complete description.