User Manual
– AS5x61/AS5x62 Programming
www.ams.com
Revision 1.0 / 10/31/12
page 11/14
b. You can go straight to burning the configuration in to the AS5x62. Go to Step 31.
23) During this procedure,
DO NOT
click on
24) Click
25) Click
26) Check if write/read Chksum is green
27) To program an AS5261(DualDie) Device, redo step 24 to step 26 for the Top Device.
28) Click
to check with an
oscilloscope
if your trimming is what you
expected.
29) If satisfied with the results go to Step 31, otherwise, go to Step19.
30) Reset the device. You have to push the reset button on the UART Interface board by hand.
This will reset the programming configuration.
31) Go to Step 4 to repeat procedure to change unacceptable parameters.
**** Permanent Programming of AS5x61 beyond this point ****
32) Reset the device.
33) Select
34) Click
This transfers all data to “Programming Mode” screen.
35) For programming the A5261(DualDie), redo point 34 and 35 at
36) Click
37) Click
This will cause the AS5x61 to permanently enter into Output Mode when
power is applied to it.
38) Click
39) Click