Amprobe AT-8000 Series, Быстрый старт

Страница: 4 / 38

Amprobe
®
| info@amprobe.com | Fluke Corporation, Everett, WA 98203 | Tel: 877-AMPROBE (267-7623)
AT-8000
2
Tracing Energized Wires - Smart Sensor
TM
TIP:
For best results, keep the Receiver at least 3
feet from the Transmitter and its test leads to
minimize signal interference and improve wire
tracing results. Select the “Long” Smart Sensor
TM
Range in the Settings Menu if working with wires
that are greater than 3 feet deep.
AT-8000-T
Receiver:
Energized Smart Sensor
TM
Mode
The Smart Sensor TM enables easier wire tracing by
showing the direction and position of the wire and is the
recommended method for tracing Energized wires.
Set-up:
Test Leads
Set-up:
Transmitter
1. Plug the green and red test leads into the Transmitter.
2. Connect the green wire to a separate ground.
3. Connect the red test lead to the wire being
traced. For receptacles, make sure to connect the
test lead to the line (hot) wire. For Energized
systems the signal will ONLY be transmitted
between the load-side to which the Transmitter is
connected and the source of power.
1. Turn on the Transmitter.
2. Verify that the test leads are properly connected;
the red LED voltage status light should be on for
circuits with voltage above 30 V AC/DC.
3. Select HIGH signal mode by pressing HI.
2
1
Proper connection
with separate
ground
1. Turn on the Receiver and select SMART SENSOR
TM
mode using the directional arrows.
2. Hold the Receiver with the Smart Sensor
TM
facing
the target area.
3. Move
the Receiver in direction indicated by the
arrow on the screen. If the screen flashes a “?” in a
red target then either no signal is detected or the
signal is not adequate enough to display direction;
increase the sensitivity using the “+” button on the
Receiver.
4. Press ENTER when complete to return to the
home screen.
AT-8000-T
TRANSMITTER
HI
LO
Blinking
Transmitter
indicator showing
signal in
HIGH mode
ENERGIZED:
DE-ENERGIZED:
--
Receiver locked on wire