5
SW225 VOICE PROJECTOR
S1204 WIRELESS SPEAKER
S1690T Microphone
Transmitter
S1691T Speaker
Transmitter
SW225 INTERNAL WIRELESS MICROPHONE RECEIVER:
Select channel (1-16) on panel
(A
)
.
Channel
number
should match
channel number on wireless microphone transmitter.
S1690T is the
microphone transmitter.
Use supplied screwdriver to select channel
number.
PLEASE NOTE: YOU HAVE TWO
SEPARATE TRANSMITTERS. ONE
IS FOR THE SPEAKER AND THE
OTHER IS FOR THE MICROPHONE.
MICROPHONE = S1690T
SPEAKER = S1691T
SW225 WIRELESS MICROPHONE TRANSMITTER:
Rotate the
Channel Selector Switch
(
B
) on the wireless microphone transmitter to the same channel selected on receiver (
A
).
Belt clip on the back of the unit clips the transmitter onto a belt or the transmitter simply can be put into a pocket. Plug the lapel micro-
phone into the
Mic Input Jack
(
C
). The microphone can be clipped to a necktie or other clothing, using the supplied clip. The lapel
mic should be placed under the chin, as close to the center of the body as possible. Slide the power
ON/OFF
switch
(
D
)
to the
ON
position (the LED indicator light will illuminate). If you are on the same channel numbers, the LED light on the panel
(
A
)
will light.
S1204 Wireless Speaker Connection
Connect provided cable from the
MIC INPUT JACK (C)
on the
S1691T TRANSMITTER
into the
LINE OUT JACK (E)
on the am-
plifier of the SW225 Voice Projector. On the S1204 Speaker select a wireless channel number that is not the same as on the
SW225 speaker. If you chose Channel 1 on the SW225 receiver / transmitter, choose Channel 10 for the S1204 receiver / transmit-
ter. Keep the Channel numbers far apart to avoid interference between the two.
Channel Selector
Top Panel
B
A
D
C
E
To Operate:
On both speakers, turn amplifiers on. Slide the wireless microphone switch on panel of both units to
“ON”.
Turn both bodypacks
“ON”
.
RF LED
on panel of amplifier will light meaning that it is receiving signal. If
RF LED
does not light, check channel numbers.
When both RF LED’s are on, speak into microphone and rotate
“VOLUME”
control knobs to obtain desired loudness level.
NOTE:
The wireless frequencies used are not on clear channels and may be used by other devices. If the S1204 speaker receives
interference and if you are unable to use the S1691T transmitter, connect the
LINE OUT
on the SW225 Voice Projector to the S1204
LINE IN
using a 3.5mm mini plug cable. Turn the main volume control on the S1204 speaker completely down and use the
AUXILIARY VOLUME CONTROL
to adjust speaker level.
WIRELESS SET-UP
