7
Plug wired handheld microphone into the
“DYNAMIC”
jack. Turn amplifier on. Turn microphone on and talk into
microphone. Rotate
“VOLUME”
control knob to obtain desired loudness level.
For Model
SW222A / SW223A / SW224A
with the built-in wireless receiver, the “
ON
-
OFF”
switch is located next
to main power switch of amplifier. Make sure both transmitter and receiver are on same frequency channel. Turn
“ON”
wireless transmitter (Bodypack S1690T) or (Handheld S1695).
RF LED
on amplifier will light, meaning
that it is receiving signal. If
RF LED
does not light, check channel numbers.
For future reference a
SET
-
UP GUIDE
has been printed on top of the amplifier chassis.
OPERATION
STORAGE COMPARTMENT:
Compartment will only hold one handheld microphone. Model SW223A /
SW224A will also hold the bodypack and lapel microphone. The headset microphone can be placed on top of
setup information area before closing the top half of case. The foam inside of the case half will hold headset in
place.
OR
Model SW224A shown with
2nd wireless installed.
MICROPHONE STORAGE
SET-UP GUIDE
BLUETOOTH PAIRING
Locate on/off switch on side of chassis.
Slide switch to
ON
. A blue LED will start to flash.
On your Bluetooth device menu select
VUBT2
to start pairing.
When successfully connected, the blue LED will stop blinking and remain lit.
BLUETOOTH
RECEIVER
1-
800-572-2194 • DISPLAYS2GO.COM
