AmpliVox SS / SW3230 RTA ASSEMBLY INSTRUCTIONS
11
SW3230RTA AMPLIFIER / MICROPHONE
INSTALLATION
AMPLIFIER
•
Unpack item (R) Amplifier and mounting
bracket. Open large front door. Using the
bracket as a guide, drill four 3/32" pilot holes.
Position bracket under top shelf as shown.
Front edge of bracket needs to be 2 ½" from
front edge of shelf
. Use the four screws that
were packed with the bracket.
•
After bracket is installed slide amplifier into
bracket.
Lubricate the side rails on the
amplifier
with any spray type lubricant,
silicone, or soap to aid in sliding the amplifier
into the bracket. Remember, amplifier needs
10 batteries to operate. Make sure that you
install the batteries before you side in the
amplifier.
•
Read separate amplifier instructions included in package.
MICROPHONE
•
Remove sliding drawer.
•
Take female end of microphone cable and starting
at the amplifier, route cable up through notch in the
back end of top shelf. Reach into cabinet space
where sliding drawer was and grab the microphone
cable and continue to route through the large
opening in reading surface.
•
Take microphone mount and insert the female end of cable into the mount from the
bottom side. Now drop the mount into the large hole and using the screws that are
packed with microphone, screw into the reading surface.
•
Place sliding drawer back into cabinet.
•
Plug microphone cable into the microphone jack marked "DYNAMIC."
•
Plug in microphone into the microphone mount.
