A M P L I F I C A Z I O N I
description of the front compressor
www
.amplificazionilombardi.it
page 6 of 13
There are 4 holes in front panel for rack
mounting. The space within a rack is 2 units.
mounting RACK
Potentiometer to adjust in increments of
compression ratio, the numerical scale of
reference shows the different compression
ratios possible.
RATIO (rapporto)
The green LED (switched "bypass" down)
indicates the channel is excluded (bypass),
then the input signal is unchanged.
LED BYPASS (escluso)
LCOMP2
Potentiometer to adjust the input volume, the
numerical scale of reference is figured in dB.
INPUT (ingresso)
This switch once and hold (with LED
"excluded" on) indicates that the channel is
excluded (bypass), then the input signal is
unchanged.
switch BYPASS (escluso)
The red LED indicates when the input signal
is too high
LED PEAK (picco)
Potentiometer for adjusting the compression
threshold, the numerical reference scale
ranges from 1 to 10. (increaseing this pot the
treshold is going down)
THRESHOLD (soglia)
Potentiometer to adjust the output volume,
the numerical scale of reference is figured
in dB.
OUTPUT (uscita)
This switch pressed (with LED "control A"
on) indicates that the channel A and channel
B are governed by only channel A.
control in channel "A" (controllo in A)
VU-meters or LED indicating the output level
or the level of compression.
LED VU-meters
This switch lets you decide if the LED VU-
meters show the output level or the level of
compression.
switch output level / level compression
(liv. uscita / liv. compressione)
LED control in channel "A" (controllo in A)
Power switch ON and OFF.
switch on/off (accensione / spegnimento)
This red LED when turned on (switch "control
A" down) indicates that the channel A and
channel B are governed by only channel A.
1
2
3
7
13
1
2
3
4
8
10
9
5
4
6
12
11
5
6
7
8
9
10
11
12
13
