Chapter 3 Reference and Installation
Installing the
HDD Mounting Kit
With front and back faceplates and top cover removed, it would be the
correct time to install the HDD kit if you wanted.
1. First, locate the HDD mounting holes on the carrier
board as shown below.
2. The HDD kit comes with a mounting bracket, a cable, some screws
and a plastic EMI shield. Since the plastic shield does not come
attached, you need to stick it on the bracket as shown in the figure
below. The same red arrows mark the corners of the plastic shield.
Connect the HDD bracket with 4 screws as shown below and apply
the EMI plastic shield. There are also 4 holes used to mount the HDD
to the bracket. It is okay to make holes through the EMI shield for
these screws, since it will overlap at least two of these HDD mounting
holes.
NOTE
:
If you would like to slide off the top cover, only the front
or back faceplate needs to be removed (only one). For example,
for installing a HDD you only need to remove the top cover of the
chassis.
3.9
Содержание Impact-E Series
Страница 1: ...Impact E20 User Manual...
Страница 4: ...Chapter 1ETX Module Reference...
Страница 16: ...Chapter 2 Carrier Board Reference...
Страница 37: ...Chapter 3 Reference and Installation...