User and Installation Guide
R
R
Page 12
Problem
Possible Cause
Solution
The transmit light
does not go on after
DC power is applied
to the transmitter
Faulty AC adapter
or faulty power outlet
Check the power outlet and
the AC adapter; if possible,
check for correct voltage of
the AC adapter.
No audio present at
audio input
Check the audio connection
to the transmitter and ensure
that there is audio present.
The transmit light
goes out after a few
seconds and does
not light again
Transmitter hung up
Disconnect and then
reconnect DC power.
Faulty AC adapter
or faulty power outlet
See under “Faulty AC adapter
or faulty power outlet“ above.
Transmitter volum e
control set too low
Adjust the transmitter volume
control.
Amplifier volum e
control set too low
Adjust the amplif ier volum e
control.
No audio at
ampli fier
Strong inter ferenc e
See under “Strong
Interferenc e“ on next page.
Transmitter volum e
control set too high
Adjust the transmitter volume
control until clipping stops.
Amplifier volum e
control set too high
Adjust the amplif ier volum e
control until clipping stops.
Audio is distor ted
Strong inter ferenc e
See under “Strong
Interferenc e“ on next page.
Transmitter volum e
control set too low
Adjust the transmitter volume
control to achiev e the desir ed
audio level.
Speaker audio level
is too low
Amplifier volum e
control set too low
Adjust the amplif ier volum e
control to achiev e the desir ed
audio level.
Troubleshooting
