K2060E030 Shaker Kit Selection and Quick Start
GuideGuide
DS-0150 revB
www.modalshop.com | 513-351-9919 | [email protected]
Connecting the K2060E030 shaker kit
1.
Connect shaker cable to amplifier (see below table)
Shaker Cable Wire Color
Function
2050E05
2100E21-400
Red
Armature
OUT / OUT
OUT /
Orange & Blue
Armature
RET / RET
RET / SHAKER -
White/Black
Interlock
+ / +
+ / Int
White
Interlock
INT / INT
INT / Interlock -
Black
Ground
GND / GND
GND / Earth Ground
2.
Connect the shaker cable to shaker.
3.
Power amplifier with included power cable
4.
Connect input signal via the BNC connector labeled “
Signal Input
”
on the back of the 2100E21-400 or to
the BNC connector labeled “AC”
on the back of the 2050E05 amplifier.
5.
Turn on master power switch and position gain knob to desired setting.
Note:
Master power switch is
located on the back of the 2100E21-400 amplifier and on the front of the 2050E05 amplifier.
2100E21-400 User Tips
•
As a safety measure, if the gain knob is not in the “mute”
position when power is turned on, it will need to
be turned
to “mute” before amplifier can be used.
•
Output clipping error: Anytime the output waveform is clipped due to too much gain or the input
amplitude being too high, the LCD screen will flash the “output clipping” message until the clipping stops.
This helps avoid unwanted output distortion. During clipping, all menus and buttons remain functional.
•
Output interlock: Anytime an error or a fault condition occurs while the amplifier is on, the amplifier will
automatically mute and a message will be displayed on the LCD.
Consult the “
Troubleshooting Guide
” i
n
the manual to fix any problem that caused the error, and press F1 to clear the error message. If the gain
knob is not turned to “mute,” it will have to be turned to “mute” first before the amplifier can be turned
back on.
2050E05 User Tips
•
Trip indicator flashing:
The “TRIP” indicator flashes if the amplifier has been turned on with the gain out
of the reset position or if the external (fault open) interlock is open. The amplifier output is inhibited
during this interlock condition. The indicator also flashes during a heat sink over-temperature condition.
The amplifier output will be compressed if the overheat condition persists but will automatically restore
itself after the heat sink temperature drops.
•
The output peak voltage bar graph indicates the peak voltage applied to the shaker and will indicate
voltage clipping limits and output signal level. It can also be useful in detecting output open circuit
problems. The output RMS current level graph indicates the amount of current being delivered to the
shaker and can be used to prevent overdriving and subsequent damage to connected loads
.
and
are available online. Feel free to contact The Modal Shop for support at
or +1 513-351-9919.
