Amphenol SSI Digital Fluid-Trac DFT-200 Series Скачать руководство пользователя страница 3

Страница: 3 / 4

ssi-sensors.com

Doc. DT-AN4 — Rev. 01

Simulate an Empty (0 gallons / 4 mA) Reading

a) Place the Digital Fluid-Trac

32 inches above the table top. Make sure the sensor is level with

the table top.

b) Press the Refresh/Select button.

c) The display should read approximately 0 gallons or 4 mA, depending on output type.

7. For DFT 200 series only (DFT-200, DFT-210, DFT-220)

Simulate a Full (55 gallons / 20 mA) Reading

a) If cable is connected in back of unit, but backlight is off, it indicates loss of power or ground

from power supply. Display may have erroneous reading during this condition.

b) When using batteries “REFRESH/SELECT” button must be pushed to update unit to current

barrel level reading.

Содержание SSI Digital Fluid-Trac DFT-200 Series

Страница 1: ...sor and media being monitored 1 If using the adapter verify the yellow acoustic absorber disc see photo to the right is properly installed inside the adapter A level sensor that is mounted or sitting...

Страница 2: ...s to select the desired volume setting e After desired volume mode stops flashing release the button The unit will then go back into level monitoring mode f The level reading can be refreshed by momen...

Страница 3: ...n c The display should read approximately 0 gallons or 4 mA depending on output type 7 For DFT 200 series only DFT 200 DFT 210 DFT 220 Simulate a Full 55 gallons 20 mA Reading a If cable is connected...

Страница 4: ...ed to the repair or replacement free of charge of such articles as are found to be defective in material or workmanship on the condition that the purchaser gives prompt written notice to SSI of any cl...