RESMLAC 8US CAPS SX - UM rev. 1.0
Page 5 of 12
Last Rev: 21-Jan-13
Amphenol
– 948, Promenade de l‘Arve – B.P. 29 – 74311 THYEZ Cedex – France - +33(0)4.50.89.28.00 –
www.rjswitch.com
Section 3
Installation
Selecting a
Site
As with any electronic device, you should place the switch where it will not be subject to
extreme temperatures, humidity, or electromagnetic interference that exceeds the
RESMLAC8USCAPSSX‘s profile. Specifically, the site you select should meet the following
requirements:
•
The ambient temperature should be between -35 to 75 degrees Celsius.
•
The relative humidity is recommended to be less than 95% percent, non-
condensing.
•
Surrounding electrical devices should not exceed the electromagnetic field (RFC)
standards for MIL-STD-461E.
CAPS for
unused
connectors
The switches are pre-equipped with caps on all ports, including power and Ethernet.
Æ
Make sure all connectors are protected with cap or sealed plug to ensure sealing
and prevent from deterioration of the contacts.
Mounting
The RESMLAC8USCAPSSX Ethernet Switch can be fastened to any flat surface by
mounting the box directly. Refer to the mechanical drawings below. Make sure to allow
enough room to route your Ethernet and power cables.
