GPS mount for GPS Antennas and Other Frequencies
DESCRIPTION
Mobile mount with a nice, “streamline”-look, which can be installed everywhere on the
car in an 19 mm dia. hole.
Especially suited for mounting on the narrow strip on rear wing between trunk lid and car
side.
M6 thread whip-mounting system.
Very low requirements to installation depth both under and after installation.
Designed for installation with access from the outside only.
Bendable section in mount makes whip tiltable 30° by hand.
Complete line of whips available for all communications bands up to 1300 MHz.
Mounting body made of stainless steel !
Choice between two connection principles:
XG-Combi mount: FME-connection and GPS (supplied without cable).
XGP4-Combi mount: Permanently attached 4 m RG 58 cable terminated with FME-
connector and GPS.
GPS-antenna for fixed installations.
Full hemispherical coverage.
Built-in high-gain, low-noise amplifier.
Right-Hand Circular Polarization (RHCP).
2.85 V - 5 V supply voltage (typical 3 V).
ECE R118.02 approved cable.
SPECIFICATIONS
Electrical
Model
XG-COMBI MOUNT
Application
Mount for mobile antennas
Mechanical
Compliance
ECE R118.02 approved cable
Build-In Depth
Active : 30 mm
Passive : 11 mm
Connection(s)
Cable : RG 178, length 150 mm
Connector: FME-male
Materials
Black-chromed brass
Weather- and shockproof plastics
Stainless steel
Installation Torque
4 ± 1 Nm
Colour
Black
Dimensions
48 mm x 28 mm (LxW) / 1.89 x 1.10 in.
Whip Connection
M6 thread stud
Weight
XG-version : Approx. 60 g
XGP4-version: Approx. 200 g
Mounting
19 mm dia. hole
Mounting Plate Thickness
Max. 2 mm
GPS Antenna
Noise Figure (GPS Amplifier)
< 1.5 dB (typical 1.1 dB)
Gain (GPS Amplifier)
22 dB -2 dB
Frequency (GPS)
1575.42 ± 1.023 MHz
Power Supply (GPS)
DC 2.85 V ~ 5 V (typical 3 V)
Current Consumption (GPS Amplifier)
<20 mA
Impedance (GPS)
50 Ω
A SELECTION OF THE VARIOUS WHIPS WHICH CAN BE CONNECTED TO THE
XG-COMBI MOUNT
XG-Combi Mount
Page: 1 of 3
Last edited: 2021/12/10