PD1240 Digital Paging Mic
PAGE 3
Parts Identification ... con’t
5. INDIVIDUAL ZONE SELECTION
Individual zone selection switch to trigger the zone selector
7. CHIME & TALK BUTTON
Select the zones required before pressing this button. A chime shall start (if selected) and followed by mic
activation, which is indicated by the illuminated ring at the gooseneck microphone.
8. GOOSSENECK MIC
This detachable condenser mic comes with illuminated ring when the mic is active mode and ready for paging.
9. MIC & CHIME VOLUME CONTROL
Individual volume for chime and microphone output level can be adjusted according to site requirement.
10. OUTPUT CONNECTION
Data and audio from other EX2800 (if any) are fed to this port forming a circuit. This connection is applicable only if
multipoint paging setup is established. Use a DC24V power adaptor supplied for powering the unit.
6. REPEAT BUTTON
Press repeat button for recall previous zone selection.
11. POWER SWITCH
This switch is for On/Off the 24V DC power.
amperes
INPUT
OU
TP
UT
EX2800
13
12
14
TO PD1280
14. PAGING MIC CONNECTION
Connect to the paging mic via this RJ45 connector. For pin configuration, refer to the diagram.
12. DATA / AUDIO OUTPUT
Data and audio are linked to TD6240 decoder unit using 2 pair screen cable. Please refer to ‘ Connecting the Unit’ for
detailed connection diagram.
13. DATA / AUDIO INPUT LINK / DC SUPPLY
Data and audio from other EX2800 (if any) are fed to this port forming a circuit. This connection is applicable only if
multipoint paging setup is establised. Use a DC24V power adaptor supplied for powering the unit.
