A. INPUT CHANNEL SECTION
1
2. LINE INPUT
The unbalanced Mic input is provided for the use of an unbalance mic and is
designed to accept an unbalanced high impedance input signal.
(This use for connection Deck, Turntable, Keyboard etc..)
1. BALANCE INPUT (MIC)
Electronially Balanced inputs acceptable a standard XLR male connector.
+ 48V Phantom Power available on each input Mic socket.
and this switch is on Rear Phantom Power.
3. TRIM
This has a function which adjusts the input sensitivity of each channel in order
to input the constant level of the signal.
4. HI EQ
This control gives you up to 15 dB of boost or cut at 12KHz and above, and it is
also flat at the detent.
2
3
4
5
6
7
8
9
7. PAN
The pan control sends continuously variable amounts of the post fader signal to
either the left and right main busses. In the center position equal amounts of
signal are sent to the left and right.
9. PEAK
A red LED indicates a signal level at the insert return point, premaster fader, It
illuminates at approximately 5dB below clipping.
8. CHANNEL FADER
This is function to adjust the volume of signal connection into each channel and
adjust the volume of output, together with master fader. Normal operating
position is at the “O” mark, providing 4dB of gain adove that point, if required.
5. LOW EQ
This control gives you up to 15 dB boost or cut at 80Hz and below. This circuit
is flat (no boost or cut) at the center detent position.
6. SEND /EFF
This is normally derived after the EQ and channel fader (POST FADE, POST
EQ), and is therefore follow any changers in fader level. They are normally
used to drive effects processing units which are fed back into the mixer and
which must fade out with the input channel.
AMP Series - 2 -
User Manual / Manual de uso
EN
