www.amp-research.com
6/9
IM76141 rev 01.20.20
A M P R E S E A R C H P O W E R S T E P
T M
– F O R D F - 1 5 0
11
3
4
Remove tape from 3/4” hole in floor panel above
front linkage on driver side and insert grommet.
Thread the two trigger wires through grommet
up into the cabin of vehicle. Seal grommet with
silicone sealer.
Route longer leg of harness down along driver-
side wheel well and along frame of vehicle.
Secure with tie wraps.
Connect red and black
power leads to battery.
Red lead goes to
positive. Route
shorter leg of harness
down passenger-side
wheel well.
Remove driver side front kick panel and door
sill plate. Roll back carpet to access hole for
grommet installation.
6
10
8
9
7
16
10
OBD II Connector located below
steering column.
Wire OBD II connector with Posi-Splice.
