Install Fixture Body to Stake
2
Clear away an area in the ground at
the wireway slot on top of the stake.
Lay the luminaire pigtail into the
wireway slot and thread the coupler
at the bottom end of the fixture body
onto the stake. Tighten until snug to
secure the base.
Fixture Body
Stake
Pigtail
Wireway Slot
Install Stake
1
Board
Stake
Soil
Ground
- 4 -
- 5 -
Determine the desired location for mounting
the luminaire. Hammer the stake into the
ground until flange of stake is flush to grade.
To avoid damage to the stake, place a board on
top of the stake while hammering.
NOTE: If the ground is hard and the stake
is difficult to install, make a crosscut in the
ground using a flat shovel.
AMP
®
OrchardPro Path Light (Lamp - Ready)
APL-3018-B-BZ
INSTALLATION & MAINTENANCE GUIDE
w w w. a m p l i g h t i n g . c o m
[email protected] • 813.978.3900
Wire Connection
3
Strip both leads from the luminaire pigtail. Using two wire connectors (sold
separaetly), connect the leads from the luminaire to the main supply cable leads.
Pigtail
Main Supply Cable
Wire Connectors
Remove Dome Lens
Install Bulb
4
5
Loosen the dome lens from the
holder to expose the socket.
Insert bulb with the correct wattage
and type marked on the fixture label.
CAUTION: Do not exceed maximum
wattage marked on luminaire label.
NOTE: DO NOT touch bulb with bare
hands. Use soft cloth to handle bulb.
Holder
Socket
Dome Lens
Bulb
