GETTING READY FOR OPERATION
Due to the considerable power of heated clothing, it is
recommended to use a fully charged battery to maximise its
operation time.
LED INDICATOR
The LED indicator is located at the top part of the ACCU
THERMO casing.
The LED indicates the battery performance status and provides
information on the current battery level.
STEP ONE
Power on, the LED lights for 4 seconds in a mode corresponding
to its charge level:
•
green, continuous: 75% – 100% of charge capacity
•
green, intermittent: 50% – 75% of charge capacity
•
red, intermittent: 25% – 50% of charge capacity
•
red, continuous: less than 25% of charge capacity
STEP TWO
Next, the LED switches to the operation “ready mode”:
•
repeated two red flashes and one green – battery ready
for operation – no receiver on the E/O output.
Once a receiver is connected and found – the E/O output
becomes active – the receiver starts being powered;
•
continuous green - when a receiver is properly connected.
USING AN UMBILICAL LIGHT
WITH ACCU THERMO
It is possible to use ACCU THERMO to simultaneously power
supply to heated clothing and an umbilical light.
However, such a gear setup is not recommended for safety
reasons.
Ammonite System recommends diving with a
primary torch, independently battery-powered,
along with two battery-powered backup torches.
To connect the umbilical light to ACCU THERMO undo
charging port plug on the ACCU THERMO terminal labelled
„charging/torch”.
Next, connect the umbilical light cable to the „charging/torch”
port by correct and firm tightening of the umbilical light cable plug.
When the umbilical light is not in use, unscrew the umbilical
light plug and then appropriately tightened up the charging
port plug.
RECOMMENDATIONS FOR USE
In the case of a longer period of non-use, the battery capacity
must be checked by connecting the charger to the charging
port. If need be, the battery should be charged up.
The indications on the charger display are only
approximate. They serve to determine the
estimated battery level.
The circuit controlling the battery performance is equipped with
a microprocessor which consumes a minimal amount of power.
Therefore, it is necessary to check the battery level in case of
a longer period of non-use.
It is recommended to take the battery pack out of the casing
and store separately in case of long periods of non-use.
Содержание ACCU THERMO 14
Страница 1: ...ACCU THERMO M A N U A L ...
Страница 2: ...ACCU THERMO HEAD MAIN BODY SAFETY VALVE ACCU THERMO HEATING BATTERIES ...
Страница 3: ...CHARGING TORCH PORT TWO STAGE POWER CONTROL E O PORT LED INDICATOR ACCU THERMO HEAD ...
Страница 8: ......
