Ammann 5932003, Руководство по эксплуатации

Страница: 73 / 174

69 ARX 23-2 T4i, ARX 26-2 T4i
OPERATING MANUAL
2.7.5 Machine parking
Shut down the machine on a flat and solid surface where there is no potential natural hazard (e.g. landslides, flooding).
Set the travel control (10) to the zero position (0).
Use the parking brake switch (17) to enable the brake.
Switch over the key in the ignition box (19) to the position “0”, take out the key from the ignition box and close the lid.
Turn off the battery disconnector if it is installed in the machine.
Clean the machine from dirt.
Check the whole machine and repair defects that occurred during operation.
Lock the cover of the dashboard and the engine bonnet with a padlock.
Note
The padlock is not delivered in the machine equipment.
Protect the dashboard and the engine compartment from unauthorized access of others by locking the dashboard cover and the
engine bonnet.
It is forbidden to use the parking brake for bringing the machine to a stop.
2.7.6 Panic response
The immediate stop of the machine using the travel control (10) applies to all of the travel modes of the machine. When the travel
control (10) is changed to the opposite position through (0) within 1 second, the machine will stop – the parking brake will be engaged
and the engine will keep running, i.e. panic response. The machine can start moving again after the travel control (10) is changed to the
neutral position (0) and the travel direction (F/R) is selected.
When the machine is equipped with two travel controls, the panic response can be enabled also on the inactive travel control.
When the machine vibration is on, the vibration will stop also when the manual vibration mode is selected.
It is forbidden to use the panic response for common stopping the machine. Enable the panic response only in emergency
when the machine must be stopped immediately.