Ammann 5932003, Руководство по эксплуатации

Страница: 61 / 174

57 ARX 23-2 T4i, ARX 26-2 T4i
OPERATING MANUAL
2.7.1 Starting the engine
Daily before starting the engine, check the oil level in the engine and in the hydraulic tank, fuel level in the fuel tank and water level in
the water tank. Check that there are no loosened, worn or missing parts on the machine.
Start the engine only from the driver’s stand! Use the warning horn to signal the engine starting and check that nobody is endangered
by starting the engine!
Starting the engine:
Turn on the battery disconnector.
Sit down on the seat.
Set the engine speed switch (18) to the idling speed position.
Set the travel control (10) to the zero position.
Check that the emergency brake (5) is not enabled.
Insert the key into the ignition box (19) in the position “0” and switch over to the position “I”.
The indicator lamps for battery charging (22), engine lubrication (23) and parking brake (29) will light up on the display (20).
Use the warning horn (15) to signal that the engine is starting.
Switch over with the key to position “II”. Be careful; if the outdoor temperature decreases under 0 °C, hold the key in the position “II” for
15 seconds!
Start the engine by switching the key to the position “III”; as soon as the engine is started up, release the key.
After the start-up, the indicator lamps for battery charging (22), engine lubrication (23) and parking brake (29) must go off on the
display (20).
When starting and driving with a cold engine and cold hydraulic oil, the braking distances are longer than when the oil
has reached its operating temperature.
Do not start the engine for more than 30 seconds. Wait for 2 minutes before starting again.
Following the engine start let the engine idle at increased speed for 3–5 min.
If the coolant temperature does not reach at least 40 °C (104 °F), do not load the engine at full power!