35
ARX 23-2 T4i, ARX 26-2 T4i
2.3.1 Short-term preservation and storage for
1–2 months
Wash and clean the entire machine carefully. Before parking the
machine for preservation and storage, run the engine to warm it
up to its operating temperature. Park the machine on a solid and
flat surface at a safe place with no risk of natural disaster (floods,
landslides, fire, etc.) for the machine.
In addition:
•
repair paints where damaged.
•
lubricate all lubrication points
•
confirm that water fillings are drained
•
check that the coolant has the required antifreeze properties
•
check that the batteries are charged and/or recharge them
if necessary
•
lubricate chromed surfaces of piston rods with preservative
grease
•
We recommend you to protect the machine against
corrosion with a preservative coating (applied by spraying),
especially where corrosion can occur.
2.3.2 Preservation and storage of the machine
for a period over 2 months
For machine shut-down, the same principles are applicable as
for the short-term preservation.
In addition it is recommended to:
•
remove the batteries, check for condition and store them in
a cool and dry room (charge the batteries regularly)
•
support the drum frame so that the shock-absorbing system
shows minimal sag
•
protect the rubber elements by coating with special
preservative agent
•
cover the suction and exhaust pipe of the engine with
double PE foil and tighten it carefully with sealing tape
•
spray a special liquid on the headlights, external rear-
view mirrors and other elements of the external electrical
installation and wrap in PE foil to protect them
•
preserve the engine according to the manufacturer's
manual – mark visibly that the engine is preserved.
After 6 months, we recommend you to inspect the
condition of preservation and renew if required.
Never start the engine during storage!
When the machine is stored under field conditions,
check that the parking place is not exposed to danger of
flooding due to floods and that there is no other type of
danger in this area (landslip etc.)!
2.3 Preservation and storage
Содержание 5932003
