NOTES:
USRA 0-6-0 ELECTRIC
USRA 0-6-0 ELECTRIC
2
General Information
This accurately detailed model is constructed of brass and stainless
steel. A large gearhead motor powers all 6 drivers through a metal
gear box and the side rods. The museum quality fi nish and lettering
represents this locomotives as its would have looked in Postwar con-
fi guration.
We recommend that you use a D.C. power supply with a capacity of
2.5 amps or large and a 24 volt output. Always pick your model up by
grasping it under the frame on both ends. It is a very heavy model so
make sure you grasp it fi rmly.
The 12 pin plug between the engine and tender takes the place of
usual “wireless drawbar” that has traditionally been found on metal
locomotives models. The drawbar on this model is just what its name
implies, a drawbar only, Both locomotive and tender units have carbon
brush pickups on both rails to ensure reliable operation when using
track power.
Disassembly of this large and complex model is not recommended.
However, if it is absolutely necessary; the 1.6 mm hex bolts and nuts
can be turned with a nut driver sized for U.S. 00-90.
Electrical Pickup
The model is powered by the DC voltage off the track through the en-
gine and the tender. All wheels are insulated on both sides of the loco-
motive, and the electricity is picked up with 12 pickup wheels. Be sure
to clean electrical pickup units before each operation. Replacement
electrical pickup units can be ordered from Accucraft Trains. Track
power is connected to the power distribution board which is located in
the tender.