AML Smart SV&T, Руководство пользователя, Страница: 11 / 27

User Manual for AML Oceanographic’s Smart SV&T
10
Configuring the Instrument for Data on Power Up
Perform the following steps:
•
Open a terminal emulation program, such as HyperTerminal, and ensure the serial port
has been selected in the program.
•
Connect the instrument to the computer using the data/power cable supplied with the
instrument.
•
Connect the power leads on the cable to a 12V DC power supply or battery.
•
Using the terminal emulation program issue the following commands to the instrument:
o
SET STARTUP NOHEADER (disables the power up header information)
o
SET STARTUP MONITOR (enable data output on power up)
o
SET DETECT 07 (set fixed 38400 baudrate)
o
SET SAMPLE RATE 10/S (set the desired sampling rate)
•
Turn off the power to the instrument.
•
Turn on the power to the instrument.
Disabling Data on Power Up
Perform the following steps:
•
Open a terminal emulation program, such as HyperTerminal, and ensure the serial port
has been selected in the program. If the instrument has been set to a specific Baud rate
with the SET DETECT command the terminal emulation program must be configured for
that baud rate.
•
Connect the instrument to the computer using the data/power cable supplied with the
instrument.
•
Connect the power leads on the cable to a 12V DC power supply or battery.
•
Turn off the power to the instrument.
•
Hold down the ‘Enter’ key.
•
Turn on the power to the instrument.
•
After several seconds release the ‘Enter’ key. This will interrupt the data on power up
mode for this power cycle.
•
Using the terminal emulation program issue the following commands to the instrument:
o
SET STARTUP HEADER (enables the power up header information)
o
SET STARTUP PROMPT (disable data output on power up)
o
SET DETECT A7 (set 10 autobaud attempts then default to 38400 baud)
o
SET SAMPLE RATE 10/S (selects the desired sampling rate)
•
Turn off the power to the instrument.