AML ez2254, Инструкция по сборке

Страница: 50 / 76

Install the main PCB to the rear panel.
Secure the make and female XLR connectors to the rear panel using the 4 Tri-rondular screws providied.
[Do not over-tighten them, the plastic of the XLR
’ s is not very strong].
If you have not already done so.... Fit the “ push ” release button to the female XLR.
Secure the IEC inlet to the rear panel using
the 2 x M3 x 10mm screws and 2 x M3 Nyloc nuts provided.
Push the spade connector of the earth cable onto the exposed terminal of the IEC inlet.
Make certain it is fully pushed on and is a tight fit. This is a safety earth connection.