AML ez1081pre, Инструкция по сборке

Страница: 28 / 43

AML
“Spanner
”
logo
on this side
T
ighten up all the screws
Solder the assembly to the main PCB
T
ransformer silk screen
print on this side
Solder the right angle pin headers to the circuit boards - the longer pin goes through the PCB - trim of
f the
excess pin (PL8 is 8-way
, PL6 is
10-way) Fit the transformer ensuring that Pins 2 to 6 are at the bottom Pins 7 to 1
1 are at the top
ie Pin 2 is nearest to the
“PL6
”
on the PCB Remove the 2 original brass screws from the end of the transformer which has the pins. (do not discard)
Fit the assembly into the main PCB and then tighten up the screws - but not too tightly !!
Remove the assembly again and then solder the transformer to its PCB
On the end of the transformer which has pins, fit an M3 nylon washer between the PCB and the transformer (this is to stop the PCB bending when screwed down). Fit loosely using the longer (6BA
x 1/4 in)
steel screws On the end of the transformer without pins fit shakeproof washers onto the original brass screws Fit the screws loosely
Input Transformer Assembly and Fitting
Original brass screws
Longer steel screws
Fit the transformer (VTB9045) to the 2 PCB
’
s as shown in the daigram.
Input
T
ransformer
PCB 1
Input
T
ransformer
PCB 2