The Charging Cradle
The cradle automatically charges the mobile computer battery
while it is resting in the cradle. The cradle also includes an extra slot
to charge a spare battery. The Charging Cradle is designed to
accommodate the mobile computer with or without the optional
pistol grip handle.
The Charging Cradle has three indicator lights:
- Indicates that the charging cradle power is on or off.
- Indicates the mobile computer main battery charge status.
- Indicates the spare battery charge status.
When the battery charge LED is red, the battery is currently
charging. When the battery charge LED is green, the battery is fully
charged. A fully discharged battery takes about 4 hours to
completely recharge. When both the spare battery and mobile
computer are charging in the cradle at the same time, the spare
battery will take longer to fully charge.
© 2020 AML
2190 Regal Parkway • Euless, TX 76040
800.648.4452 • Local: 817.571.9015
© 2020 AML
2190 Regal Parkway • Euless, TX 76040
800.648.4452 • Local: 817.571.9015
© 2020 AML
2190 Regal Parkway • Euless, TX 76040
800.648.4452 • Local: 817.571.9015
Spare Battery
Introduction
The ACC-7725 Mobile Computer Charging Cradle charges any
M7700 Striker or M7800 Scepter Mobile Computer and the spare
battery.
About This Guide
This guide provides instructions on setting up and using the
ACC-7725 charging cradle.
Set Up
Setting up the cradle includes unpacking, connecting the power
supply, and positioning the cradle on a tabletop.
Unpacking the Cradle
The shipping box includes the following:
·
One ACC-7725 Charging Cradle
·
One PWR-8050 Power Supply (12 VDC, 2.5 A)
·
This User’s Guide
Connecting the Power
The PWR-8050 power supply, included with the charger, is intended
for 120VAC operation.
To connect power to the cradle:
1. Plug in the PWR-8050 power supply to a standard 120 VAC
electrical outlet.
2. Connect the plug on the end of the power supply into the round,
barrel-jack connector, marked “12VDC” on the back of the cradle.
3. After 2 seconds the cradle power LED, on the front panel, will
illuminate red to indicate power is connected.
Charging
Set the M7700 Striker or M7800 Scepter Mobile Computer into the
cradle and it will begin charging immediately.
Indicator Lights
Troubleshooting
Cradle power indicator
does not light.
Symptom
Cause
Correction
Cradle is not receiving
power.
Make sure the
PWR-8050 power supply
is securely plugged into
the electrical outlet
and its power cord is
securely connected to
the cradle.
Mobile Computer
Indicator does not
illuminate.
Mobile computer is not
firmly seated in the
cradle, or there is no
battery in the device.
Misalignment occurs
when cradle contacts
are bent or damaged.
Make certain there is a
battery in the device,
and that the device is
firmly seated in the
cradle. Return cradle to
an AML repair center for
corrective action.
Spare Battery Indicator
does not illuminate.
Spare battery is not
seated properly in the
spare battery charging
compartment.
Reseat the spare
battery in the spare
battery charging
compartment.
Cradle Power
Indicator
Mobile Computer
Indicator
Spare Battery
Indicator
RED
= The cradle has power from the power supply.
OFF
= The power supply is disconnected or not
plugged into the electrical outlet.
RED
= The mobile computer is charging.
GREEN
= The mobile computer is fully charged.
OFF
= The mobile computer is not in the cradle.
RED
= The spare battery is charging.
GREEN
= The spare battery is fully charged.
OFF
= The spare battery is not in the cradle.