Main Active Speaker Wire Connection:
Connect the audio wires connecting active speakers to three passive speakers through conduit. Pre
terminate the wire and connect the Phoenix plug to the wire. Punch the knockouts on the sides of the
handy box. After the connection is made, make sure to close the handy box with the cover provided.
The audio wires should be a two conductor wire with recommended 18 AWG wire.
Connect the Ethernet signal wires through conduit, terminate with RJ45 connector, punch the one of
the knock out where RJ45 jack is located, than plug it into the speaker. After the connection is made,
make sure to close the handy box with the cover provided.
Companion Speaker connection.
Connect the audio wire from active speaker to the passive speakers. Make sure that the connections
are for the right channels of the speaker.
Punch the one of the knockout on the side of the handy box. After the connection is made, make
sure the close the handy box with the cover provided.
The connection on the top as
shown is to be connected to same
zone speaker (
Channel 1
) as the
main active PoE speaker.
CONNECTOR MARKED IN
PINK
COLOR WILL BE THE SAME
CHANNEL AS ACTIVE SPEAKER
The bottom two connections
are for audio output to two
(2) passive speakers for
different zone (
Channel 2
)
The connection should be
made Cat5 or above cable for
the Ethernet connection.
There is a single 2
position phoenix
connection inside of the
handybox.. THE
PASSIVE SPEAKER
THAT WILL BE THE
SAME CHANNEL
SPEAKER AS THE
ACTIVE SPEAKER HAS
PINK
MARK ON THE
PHOENIX CONNECTOR.
