![Amino Remote Controls Скачать руководство пользователя страница 18](http://html1.mh-extra.com/html/amino/remote-controls/remote-controls_configuration-manual_2933159018.webp)
Amino Remote Control Configuration Guide
Page 18
Macros are retained when the remote battery is replaced.
The TV brand code can be changed without affecting the macro. The TV
brand code only affects the IR protocol that is transmitted for each TV
function.
10.6 User Macro Programming
10.6.1 To enter the macro programming mode.
1. Press and hold STB and TV buttons simultaneously for 2 seconds
2. Both STB and TV buttons continuously illuminate
3. Press the STB or TV button to select the mode for the macro. The
button will flash off and on again once.
4. Press the button that is required to store the macro
5. Press the STB or TV button and then the required function
6. Repeat step 5 above up to a maximum of 4 times to program 4
sequential commands into the button
7. In order to enter a pause, press either STB button, ‘n’ times, where n
is the required delay in 500ms increments, up to a maximum of 4
button presses. (A pause does not count as one of the 4 macro
program steps)
8. At the end of the macro program, in order for the macro to repeat,
press the TV button once. Omit this step if the macro is to be
transmitted once for each button press.
9. Press and hold the STB and TV buttons simultaneously for 2
seconds to end the macro recording.
10. The STB and TV buttons go dark and the macro is stored.
Any key can be programmed with a macro.
If a macro has been locked into the remote at the factory, the above procedure
will not overwrite the existing macro.
EXAMPLE
A repeating TV macro is programmed into the MENU button. This macro turns
the TV on, pauses a second, tunes the TV to channel 99 and turns the STB on.
The macro steps are as follows:
1. Transmit the TV code for power
2. Pause 1 second
3. Transmit TV code 9
4. Transmit TV code 9
5. Transmit STB code for power
In order to program this macro, the following buttons are pressed.
Содержание Remote Controls
Страница 16: ...Amino Remote Control Configuration Guide Page 16 Customisable 4 x 4 button panel...
Страница 41: ...Amino Remote Control Configuration Guide Page 41 13 Appendix C Example Configuration Specification Layout...
Страница 46: ...Amino Remote Control Configuration Guide Page 46...
Страница 71: ...The Amino European Remote Page 21 YOKO 060 151 ZANUSSI 007 010 035 041 045 095 190 206 210 211 ZOPPAS 045...