16
Using the r
emote contr
ol with your TV
Configuring the remote control
In order for the remote to transmit the correct signals to control the TV, the remote must be
programmed with a three-digit code corresponding to the type of TV in use.
To do this proceed as follows:
• Identify the make of the TV; eg Sony, Magnavox etc.
• Find the TV make listed in the TV brand code tables in the next section.
• Simultaneously press and hold the
TV
and
OK
buttons on the remote.
After approximately two seconds, the
TV
button will light.
• Release the
TV
and
OK
buttons.
The TV button remains illuminated.
• Enter the three-digit brand code according to the make of the TV that is being controlled.
As each of the digits are entered, the
TV
button will briefly flash off and on again
When the third digit has been entered, the
TV
button will go out.
If a TV brand code has been entered that the remote does not recognize, the
TV
button will flash
rapidly for a second and remain illuminated. If this happens: re-enter the correct TV brand code.
• Verify that the remote control works with the TV.
Most TV makes have more than one brand code listed in the brand code table – if this is the case try
all brand codes that are listed for that make until a suitable match is found.
If no brand code is listed for the TV, try brand codes for Philips and NEC TVs.
If no brand code works for your TV, please contact your service provider who may be able to help.
Controlling a TV
To control the TV press the
TV
button on the remote control. The
TV
mode–select button will light
for one second to indicate that the mode has been set.
When any valid function button on the remote is pressed, the
TV
button will light to indicate that a
command is being transmitted in TV mode.
AmiNET124 User Guide 3/6/05 11:48 am Page 16
