Amica ZWM 626 W, Инструкция по эксплуатации

Страница: 17 / 25

14
A forgotten dish can be added at any time before the detergent cup opens.
Open the door a little to stop the washing.
After the spray arms stop working, you can open the door
completely.
Load the forgotten dishes.
Close the door, the dishwasher will start running again
after 10 seconds.
4
3
2
1
It is dangerous to open the door when washing,because the hot water may scald you.
When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they
are still hot and more susceptible to breakage. They will also dry better.
Turning on the Appliance
1 Draw out the lower and upper basket, load the dishes and push them back.
It is commended That loading the lower basket first, than the upper one (see the section entitled
Loading the Dishwasher ).
2 Pour in the detergent (see the section entitled Salt, Detergent and Rinse Aid ).
3 Insert the plug into the socket. The power supply is 220-240 VAC /50 HZ, the specification of the
socket is 10 A 250 VAC. Make sure that the water supply is turned on to full pressure.
“ ”
”
4 Close the door, press the ON/OFF button, and the ON/OFF light will turn on.
Press the Program Button to select a desired Wash cycle, the machine will work after 3 seconds.
Starting a cycle wash
NOTE:
If you open the door when washing, the machine will pause. The program light will stop blinking
and the buzzer will mooing every minute unless you close the door. After you close the door , the
machine will keep on working after 10 seconds.
ll of the program lights cut of f
)some of the program lights fast blinking -->error
The program lights shows the state of the dishwasher:
a) A --> stand by
b) One of the program lights on --> pause
c) One of the program lights blinking slowly --> run
d
If some of the program lights begin to fast blinking after a warning sound
(page 21th "ERROR CODES"), that indicates the machine is out of order, please
turn off the main power and water supply before calling a service.
NOTE:
PREMISE:
Otherwise, the detergent may have already been released,
and the appliance may have already drained the wash water. If this is the case,
the detergent dispenser must be refilled (see the section entitled " Loading the
Detergent " ).
There are two ways of changing the programme :
1. Press the button of running prog. more than 3 seconds to cancel it, then push the button of desired prog.
and it will run after 10 seconds.(see the section entitled " Starting a wash cycle. . . " ).
2. Press Button of desired prog. (except buttom of running pro.) more than 3 seconds to change
the running prog. into the prog. which you press, it will run after 10 seconds.
You can modified the washing program, just the dishwasher has been
running for a short time.