Amica VM 1055, Руководство по эксплуатации

Страница: 22 / 28

22
CLEANING AND MAINTENANCE
EN
Replacing the dust bag
Before replacing the dust bag, remove the
power cord plug from the wall outlet. Al -
ways use the vacuum cleaner with a fitted
dust bag. If you forget to insert a dust bag
or it is fitted incorrectly, the cover cannot
be closed completely ­ fix the position of a
dust bag and close the cover
1. After disconnecting flexible hose, open the front
cover by lifting it upwards (Fig. 3, ittem 9, 10).
2. Release the dust bag lock and remove the bag
from the guides, if filled with dust.
3. Insert a new or empty dust bag by sliding it into
the guides.
4. Close the cover by pressing it down until it clicks.
l
Before cleaning the filter, remove the
power cord plug from the wall outlet.
l
The filter shall be cleaned when there
are visible stains on it, wash the filter
in warm water with no detergent. Use it
only when completely dry.
l
Always use the vacuum cleaner with a
filter in place.
l
Failure to install the filter may result in
motor damage.
1. Remove the dust bag.
2. Remove the filter by sliding it up from the guides
(Fig. 3, ittem 11).
3. Clean the filter or replace.
4. Replace the filter again placing it in the guides.
Make sure that the filter before the foundation
was completely dry.
Cleaning and replacing the inlet filter
Rinse the filter with lukewarm water and let dry
completely
l
Before cleaning the filter, remove the
power cord plug from the wall outlet.
l
Clean the filter when it is clearly soiled.
Shake dirt off the filter and then brush
it with a soft bristle brush. Then rinse in
lukewarm water, without any detergent.
Do not direct strong jet of water onto the
filter. Use it only when completely dry. In
case of heavy soiling or lasting damage,
replace the filter with a new one.
l
Depending on the intensity of use, it is
recommended that you clean the filter
once a month and replace it with a new
one every six months.
l
It is recommended that you only use
original Amica filters for your vacuum
cleaner.
1. Open the air exhaust cover (Fig. 3, ittem 12, 13).
2. Remove the filter, clean or replace it with a clean
one.
3. Close the air exhaust cover.
Cleaning and replacing the outlet filter EPA12
Filters cleaning.
If the dust bag full indicator (Fig. 1, ittem
6) goes on, check whether the suction
brush or the cleaning head, hose or tube
is not blocked with large items stopping
the air flow. After removing the items, if
present, restart the vacuum cleaner - if
the dust bag full indicator is still red,
replace the dust bag with a new one.