24
temperatures. If the hob is to be installed above a working drawer,
then a partition should be fitted to protect the contents and user
from the heat generated during use. This should be fitted at least
15mm below the hob. This panel should have a ventilation space at
the rear of greater than 30mm as shown in Fig. 10 on page 25.
•
Never place perishable foods in the cupboard below the appliance.
How to install the hob
1. Make the required hole in the worktop. Note that before doing this,
check the instructions supplied with any cooker hood to ensure that
you will have the required clearance. The cut-out (Fig. 11) shows a
61.5mm gap from the wall to the cut-out edge. The distance for
the hob, when fitted, to the back wall is 50mm.
2. Position the hob seal, as shown in Fig. 13 on page 25, ensuring that
the ends meet without overlapping. Do not use silicone type sealant.
3. Secure the hob to the worktop using the fixing brackets and screws
supplied, as shown in the following diagram (Fig. 14). Remove any
excess seal after tightening the brackets.
DO NOT MODIFY THE HOB IN ANY WAY. TO DO SO MAY BE
DANGEROUS.
Installation Dimensions (mm)
AGH7100
AGVH7300
Overall width
680
700
Overall depth
500
510
Hob thickness
90
100
Worktop cutout width
557
557
Worktop cutout depth
477
477
