20
OPERATION
Set current time
When the appliance is plugged into the elec-
trical mains supply, or when power is restored
after power outage, the digital display will
show flashing
0.00
.
●
Press the
OK
button,
then the display will
show flashing dot between digits.
●
Use the
<
/
>
buttons within 7 seconds
to set the current time.
To store the new time setting, wait approxi-
mately 7 seconds after time has been set.
The dot between the digits will stop flashing.
Time setting can be adjusted later by press-
ing the
<
/
>
button simultaneously, dot will
start flashing. Time setting can be adjusted
as long as dot is flashing..
Minute Minder
The minute minder can be activated at any
time. The setting range is up to 99 minutes
and 50 seconds, with 10 seconds resolution.
To set the Minute Minder:
●
Press the
OK
button, then the display will
show flashing
symbol.
●
Use the
<
/
>
button to set the Minute
Minder.
The display will show the set time and minute
minder symbol .
Once the set time elapses, alarm sounds and
the icon blinks.
●
Press the
OK
button to mute the sound.
The
indicator will be off and the display
will show the current time.
Note: If no button is touched, alarm will turn off
automatically after approximately 7 minutes.
Timer setting may be cancelled at any time:
●
Press
OK
to select Minute Minder.
●
Press the
<
/
> buttons simultaneously.
Change the beep tone
You can change the beep tones as follows:
Press and hold the
<
/
> button simul-
taneously,
press
OK
to select
tone
, and the display
will flash:
press
<
/
>
to select the desired tone:
use the
>
button to select tones 1 to 3
use the
<
button to select tones 3 to 1.
Adjust display brightness
You can adjust display brightness 1 to 9,
where 1 is the darkest and 9 is the brightest.
The brightness setting applies to an inactive
control panel, i.e. when none of controls are
used 7 seconds.
You can adjust display brightness as follows:
simultaneously press the
<
/
>
buttons
press
OK
repeatedly to select the
bri
(brightness) setting — the settings can
be accessed in sequence
ton
(tone) and
bri
(brightness).
use the
<
/
>
buttons to select the desired
brightness
use the
>
button to select tones 1 to 9
use the
<
button to select tones 9 to 1.
Note:
The display is at its brightest setting when
active, i.e. a control was touched within the
last 7 seconds.
Night Mode
The display is dimmed during the night hours
22:00 — 06:00.