14
0
0 00
OK
2
3
1
Electronic programmer
– functions
OK
– function selection button
1
<
– “–” button
2
>
– “+” button
3
OPERATION
Setting the time
After connection to the mains or reconnection
after a power cut the display shows flash 0.00:
Timer
The timer can be activated at any time, re-
gardless of the status of other functions. The
timer can be set for from 1 minute to up to 23
hours and 59 minutes.
To set the timer you should:
Press button 1, then the display will show
flashing
,
Press button 1, then the display will show
,
set the time using buttons
3
and
2
.
7 seconds after the time has been set the
new data will be saved.
Current time can be adjusted by simultane-
ously touching the sensors
2
and
3
. The
display will start blinking. Adjust current time
as required.
Caution!
If the correct time is not set then proper opera-
tion of the oven is not possible.
0
0 00
OK
set the timer using buttons
3
and
2
.
The time set is shown on the display and the
signal function is on.
Press button
1
,
2
or
3
in order to switch off
the signal, the signal function will go out and
the display will show the current time.
Caution!
If the alarm signal is not turned off manually,
it will be turned off automatically after approx.
7 minutes.
