AMI Ecast View B75B, Руководство по установке

Страница: 6 / 8

Page 6 of 8
26683851
REV. A
17.
Connect the (4) pin ATX power supply housing to the header labeled “CN1 Power” on the
I/O Board. Connect the (20) pin housing of the front panel harness to the header labeled
“CN5 Core Control” on the I/O Board. Connect the (10) pin COM to I/O ribbon cable to the
header labeled “CN6 RS232” on the I/O Board as shown in Figure 8.
Figure 8
18. Double check that all harnesses are properly connected and all mounting screws are tight.
Reinstall the Computer Core back into the jukebox. Reconnect all harnesses to the AMI
View I/O board and touch screen cables removed in Step #4.
Power up Testing
19.
Plug the jukebox back into the wall outlet then power up the jukebox to ensure the jukebox
UI comes up. This will take some time and may include one or more reboots.
20.
In order for the jukebox to connect to the AMI network, the MAC address of the computer
core must be entered into the AMI database and the jukebox will have to be added to your
operating contract. This will require a phone call to the AMI Tech Support line, 1-877-ROC-
N-ROL (1-877-762-6765).
21.
The MAC address is found on a Service Mode screen.
22.
If the jukebox is not in the Service Mode, push the Activate Service Screen button on the
core computer I/O board.
23. Push the Calibrate Touch Screen button and calibrate the touch screen.
24.
Touch Diagnostics then touch System Information. The MAC address will be displayed in
the third block down from the top right.
ATX POWER
FRONT
PANEL
COM to I/O