AMG VieIla V12, Инструкция по установке и эксплуатации

Страница: 14 / 16

We also supply a cinch box made of solid aluminum and a pcb with two high quality cinch connectors
and a 2 mm ground connector. If your turntable does not have connectors fit in.
Adjustment procedures
Slide the tone arm with the shaft into the mounting bushing. If you got the version with the female
connector in the bushing ( in combination with the Viella turntable ) be sure both connectors are
matching before you push the arm shaft to the detent.
Slide the counterweight onto the arm tube and balance it, so the tube is horizontal and free swiveling.
Be sure, to adjust the height so your cartridge clears the platter. The active range of the antiskating
system is about 250 mm. Turn the arm shaft, that the cartridge is about 90 mm away from the platter.
Take a # 1.5 hex screwdriver and lock the locking screw in the mounting bushing.
To continue, it is recommended to set the antiskating to minimum. In the flange of the arm shaft are
left and right two screws. Take the # 1.5 hex screwdriver, loosen them a bit and slide them all the way
down. This is what moves the antiskating magnetos away from the ring magneto in the bearing case.
And your antiskating force is set to minimum.
Now adjust the vertical tracking force ( VIP ) with a scale. It is essential, that the arm tube is in a
horizontal position while resting on the scale. If your scale sits much higher on the platter than a
record, set it on a piece of wood aside the platter. When VIP is set, gently fasten the locking screw in
the counter weight with the # 1.5 screwdriver.
The tone arm lift is preset at the factory. If you like to raise your stylus higher or lower, the lift slides in
the bracket by loosening the locking screw in the bracket with the # 0.9 screwdriver.
Cross check your pivot to turntable center distance. I f the tone arm is mounted to a Viella turntable,
please check if the dial on the right side of the arm board is set to zero. This adjusts your distance
correctly.
Now put a record on the platter and set the VTA until the spirit level in the arm hub shows horizontal.
Assuming your turntable is set to horizontal.
Take the # 1.5 screwdriver, loosen the locking screw in the mounting bushing flange and if you have
the two connectors with a Viella turntable, loosen the connector locking screw in the arm board as
well. Adjust the VIA with the height adjustment screw in the lift bracket. Tighten the locking screw(s)
again.
Now set the correct overhang by using a good template.
The antiskating system is very effective. To start with leave the left hand magneto in the lowest
position and bring your right hand magneto up by two thirds with the # 1.5 screwdriver.. Than continue
with a measuring record or Wally Tools Wallyskater or something equivalent.
The tone arm also has a azimuth adjustment. It is set to zero at the factory. If you do not have
appropriate measuring equipment, like a Fosgate Fosgometer, it is not recommended to use it.
If you like to make azimuth adjustments, take the # 1.5 screwdriver loosen the locking screw at the left
side of the tube hub. Then adjust the azimuth by little increments with the screw on top of the hub.
Press the hub gently down by your finger while tightening the locking screw again.
Now enjoy your music. We like to wish you lots of joy with this precision product.
Werner ROschlau