AMG Systems Ltd. reserves the right to make changes to this
document without notice. The information herein is believed to
be accurate. No responsibility is assumed by AMG for its use.
Page 4 of 8
AMG5612 Instruction Sheet D17078-
02.doc
Connections
Video Output Connection
Connector ............................................75 ohm BNC Socket.
Output Impedance ...............................75 ohm terminated.
Output Level ........................................1 Volt p-p nominal
Frequency Response...........................10Hz to 7MHz.
Optical Connections
No. of Optical Connections ..................1 per video channel
Optical Fibre ........................................Multimode 50/125 or 62.5/125**
Connector ............................................SC/PC
Minimum Optical Sensitivity.................-30dBm
Receive Wavelength............................1310nm
Optical Link Dynamic Range ...............20dB.
**Note: the transmission distance is limited by the bandwidth of the Multimode optical fibre. The optical
data rate is 155Mbits/s, which may restrict operation to a maximum fibre length of 7km, although in
most cases the units will operate successfully over longer fibre lengths. It is advisable however for
distances greater than 7km, to have the optical fibre tested.
Power Connection
Connector Type ...................................Removable 2-pin, 3.81mm, Screw Terminal
Connector Partno.................................Phoenix 1803578
Supply Voltage.....................................+12 to +15 Volts DC
Maximum Power ..................................1.5 Watts
Front Panel Indicators
Power LED
Power / Video / Opto............................Green
-
Video present & opto sync.
R/G
-
Opto sync. but no video present.
Red
-
No opto sync.
Off
-
No power applied to unit.
