AMG Systems Ltd. reserves the right to make changes to this
document without notice. The information herein is believed to
be accurate. No responsibility is assumed by AMG for its use.
Page 4 of 8
AMG4701ER-CWDMn Instruction
Sheet D16885-01.doc
Connections
Optical Connections
PRIMARY OPTO OUT
Connector ............................................LC/PC
Primary Optical Launch Power ............0dBm
Wavelength..........................................Defined by '
n
' in the AMG Partno.
Optical Fibre ........................................Singlemode
PRIMARY OPTO IN
Connector ............................................LC/PC
Primary Optical Sensitivity...................-22dBm
Wavelength..........................................Any 1310nm or 1550nm band
Optical Fibre ........................................Singlemode
Optical Overload ..................................-5dBm
NOTE: The optical launch power may overload the input of an AMG receiver if connected directly. A
minimum of 5dB loss is required to ensure correct operation.
Power Connection
Power supply .......................................from plug in connection on the AMG2009 / AMG2015 subrack
Power consumption .............................5 Watts max.
Ethernet Connection
Ethernet Data Connector ....................RJ45
Interface...............................................Auto-negotiation up to 100BASE-TX full duplex
Ethernet Data Rate ..............................Maximum 100Mb/s total Ethernet traffic on fibre
Ethernet Operation
In order for the AMG system to transmit Ethernet signals, an onboard RJ45 Ethernet interface or
X16003 Ethernet interface adaptor should be fitted to both the Transmit unit and the Receive unit.
The Ethernet interface can operate at either 10Mbits/s half duplex, or 100Mbit/s full duplex, and data is
transmitted from one port the other port with the minimum of delay or buffering.
The 100BaseT port does not implement MDI/MDIX; it should be connected with a straight though
cable to an external switch port and with a cross over cable when connected directly to a PC or DTE.
