AMG AMG4642E Скачать руководство пользователя страница 4

AMG Systems Ltd. reserves the right to make changes to this
document without notice. The information herein is believed to
be accurate. No responsibility is assumed by AMG for its use.

Page 4 of 8

AMG4642E Instruction Sheet D18139-
01.doc

Connections

Video Output Connections

No. of channels....................................4
Connectors ..........................................75 ohm BNC Socket.
Output Impedance ...............................75 ohm terminated.
Output Level ........................................1 Volt p-p nominal
Frequency Response...........................10Hz to 7MHz.

Optical Connections

PRIMARY OPTO OUT

Connector ............................................LC/PC
Primary Optical Launch Power ............-5dBm
Wavelength..........................................1310nm
Optical Fibre ........................................Multimode 50/125 or 62.5/125**

PRIMARY OPTO IN

Connector ............................................LC/PC
Primary Optical Sensitivity...................-22dBm
Wavelength..........................................1310nm
Optical Fibre ........................................Multimode 50/125 or 62.5/125**

**Note: the transmission distance is limited by the bandwidth of the Multimode optical fibre. The optical
data rate is 1.25Gbits/s. The maximum bandwidth specification at this data rate for Multimode fibre is
2km. although in most cases the units will operate successfully over longer fibre lengths. It is
advisable however for distances greater than 2km, to have the optical fibre tested.

Power Connection

Connector Type ...................................2.1mm screw lock long power jack – centre positive
Connector Partno.................................Switchcraft S761K, AMG G16125-00
Supply Voltage.....................................13.5 to 18.0 Volts DC.
Maximum Power .................................10 Watts

Ethernet Connection

Ethernet Data Connector ....................RJ45
Interface...............................................Auto-negotiation up to 100BASE-TX full duplex
Ethernet Data Rate ..............................Maximum 100Mb/s total Ethernet traffic on fibre

Ethernet Operation

In order for the AMG system to transmit Ethernet signals, an onboard RJ45 Ethernet interface or
X16003 Ethernet interface adaptor should be fitted to both the Transmit unit and the Receive unit.

The Ethernet interface can operate at either 10Mbits/s half duplex, or 100Mbit/s full duplex, and data is
transmitted from one port the other port with the minimum of delay or buffering.

The 100BaseT port does not implement MDI/MDIX; it should be connected with a straight though
cable to an external switch port and with a cross over cable when connected directly to a PC or DTE.

Содержание AMG4642E









Отзывы: