Seite 8 von 17
AMG Sicherheitstechnik GmbH
Industriepark Straße A-9
39245 Gommern
Telefon 039200-7797-0
Freecall 0800-2264264*
Fax 039200-7797-29
Geschäftszeiten sind von 8-17 Uhr, außerhalb dieser Zeit ist ein Anrufbeantworter geschaltet
*) kostenlos aus dem deutschen Festnetz und allen deutschen Mobilfunknetzen
Inserting the SIM card:
Open the housing by loosening the 3 screws on the back of the device and carefully pull
apart the two halves of the housing. Slide the metal bracket inward and fold it up. Insert
the micro SIM card into the slot, close the metal bracket, and slide the bracket outward
so that the SIM card is secure.
Then plug both halves together again. Make sure that the halves are placed straight on
top of each other. Finally, secure the housing through the 3 loosened screws.
Blue SIM credits charge
There are several ways to charge the SIM card. We will now list these and briefly
describe how the procedure is.
1.
ATMs, here you can recharge your credit (for more information about the career,
please ask an employee of the bank branch). If the charge was successful you will
receive an SMS, it is important to put the SIM card in a mobile phone, so that the
credit is booked on.
2.
Online charging, here you have to go to Blau.de and then follow the steps until a
code is sent via SMS, which in turn must be entered online. For this purpose, the
SIM card must be placed in a cell phone, so that one receives the SMS and can
enter the code in the online portal of Blau.de.
3.
Prepaid charging, here you have to remove the card and place it in a cell phone,
then follow the instructions step by step.
BLUE SIM ONLY USE IN GERMANY
Connection of the base station
Connect the USB cable to the power supply and to the connector on the charging cradle.
The red light on the front of the base station then lights up at a loss. Place the GPS
emergency transmitter in the base station so that the red light illuminates brightly. The
GPS emergency transmitter will now charge.
Teaching sensors
Note: The sensors are delivered factory-installed.
To teach in a sensor, just press the button on the back of the base station once and then
trigger the radio signal from the sensor by pressing the emergency button. If the sensor
has been learned correctly, you will hear a beep from the base station each time it is
triggered.
Delete all learned sensors
To clear all sensors, press and hold the teach-in button on the back of the base station
for more than 5 seconds, then all sensors are deleted from the device and can be re-
taught.
