5
Pick up the Top
(#1)
and Column
(#6)
and place over the round
tube on the Base
(#7)
inside of the magazine rack. Be sure the
Column
(#6)
has dropped down all the way!
6
Remove the black shipping screw in the column and replace it with
the zinc plated screw
(#3),
using a Phillips screwdriver.
Fig. 3
OPERATION INSTRUCTIONS
A
To elevate the table, push upwards at any position on the underside of the top
,
until the top has reached
the desired height.
B
To lower, squeeze the trip handle up towards and push the top down to the desired height. The table
will operate best if the downward pressure is placed at the column end of the top
C
Occasional application of light oil lubrication between the inner and outer columns will help keep your
Over Bed Table operating smoothly. Penetrating oils with rust inhibitors are recommended.
D
The table will swing a full 360 degrees around on the base to be used as an end table or a lap tray as
needed.
!
Rev. B 03/03/16
