Ametek Sorensen SG Series, Руководство по программированию, Страница: 40 / 149

Ethernet Configuration and Remote Programming SG Series Programming
5-6
M550129-03 Rev L
c. In the Network Connections window, right click the icon for
the network adapter used to connect to the power supply,
and click
Properties .
d. Find the TCP/IP protocol item under the Configuration tab
(for XP: find the item under the General tab), and click
Properties . Select Obtain an IP Address Automatically.
e. Click OK to save the change.
f. Click OK again to apply the settings to the network
adapter.
4. In Windows, click Start , and then
Run…
5.
In the Run window, type “ipconfig /release” and click
OK .
6. Again click Start, and then
Run…
7.
In the Run window, type “ipconfig /renew” and click
OK . Your PC will
assign itself an IP address in the Auto-IP range.
8. Power on the power supply and allow the power supply to perform its
initialization.
9. Identify the IP address assigned to the power supply by discovering it
with a
VXI-11 compliant discover program.
10. Continue by following the procedure in Section 5.2.4.
NOTE: When Auto-IP assigns an IP address, Web page connections will
time out after 5 minutes of inactivity, which requires logging in again.
5.2.3
Network Setup Using the Serial COM Port
1.
Connect from the PC CO
M1 port to the power supply’s RS232 port
(see Figure 5-1 for port location) using a cable with an RJ modular
plug to D-Subminiature connector (refer to details in Section 3.2).
2.
Have ready the IP address (e.g. 192.168.0.200) and subnet mask
(e.g., 255.255.255.0) to be assigned to the power supply.
3.
Run a serial terminal program, such as MS HyperTerminal
TM
. Set the
baud rate (bits per second) to 19200, data bits to 8, parity to none,
stop bits to 1, flow control to none. Establish the connection.
If you choose to use MS HyperTerminal
TM
:
a. After inputting the above parameters, in the HyperTerminal
TM
window click the Disconnect icon and then the Properties icon.
b. In the Properties window select the Settings tab.
c. In the Settings window click the ASCII Setup button.
d. In the ASCII Setup window in the ASCII Sending section,
check “Echo typed characters locally” and in the ASCII
Receiving section, check “Append line feeds to incoming line
ends.” Leave all other check boxes in their default state.