Ametek Sorensen SG Series, Руководство по программированию, Страница: 35 / 149

M550129-03 Rev L
5-1
SECTION 5
ETHERNET CONFIGURATION
AND REMOTE PROGRAMMING
5.1
REAR PANEL
This section provides illustrations of the SG power supply’s rear panel layout,
which differs among the SG models. Figure 5-1, Figure 5-2 and Figure 5-3
are examples. Regardless of the layout, the component functions are
common across all models, and those that are pertinent to the Ethernet
option are described here.
Figure 5-1. SG Rear Panel with Ethernet/RS232 Options
1
– Ethernet (RJ-45) connector. Adjacent to the RJ-45 connector are two green LEDs.
If one of the LEDs is lit, the link is connected either to a hub switch or to another
host. If both are lit, the connection speed is 100MB.
2
– RS232 (RJ-type 6P6C) connector.
3
– Reset switch and green dual-purpose NET LED.
Reset switch (must be depressed until NET LED begins blinking, which could take
five or more seconds) returns configuration parameters to factory default settings
(see Section 4.3.2).
NET LED: when solid-lit, indicates Network Connectivity; blinking indicates
Instrument ID (See “Instrument ID” in
Settings , Section 5.5.3). If the LED is off,
there is no Ethernet connection found by the power supply.
4
– Configuration Switch (may be 8-pin or 4-pin). For correct settings see Section
5.2.5)
5
–External User Control Signal Connector (see Section 5.3)